GabrielTofvesson
41f95d2077
Added callback/timeout module Added pixel location output to VGA module Fixed state management for RAM module Lowered clock speed for circuit to 200MHz because 400MHz was unstable. NOTE: even 200MHz is quite unstable
47 lines
1.7 KiB
Verilog
47 lines
1.7 KiB
Verilog
module RAM(
|
|
input wire clk,
|
|
output wire [10:0] RAM_addr, // RAM address buffer
|
|
output wire RAM_A10, // RAM address/auto-precharge
|
|
output wire [1:0] RAM_bank_sel, // RAM bank selection
|
|
inout wire [15:0] RAM_data, // RAM data bus
|
|
output wire RAM_clk, // RAM clock signal
|
|
output wire RAM_clk_enable, // RAM enable clock
|
|
output wire RAM_enable, // RAM chip enable
|
|
output wire RAM_strobe_row, // RAM row strobe
|
|
output wire RAM_strobe_col, // RAM column strobe
|
|
output wire RAM_write_enable, // RAM data bus write enable
|
|
input wire read_rq, // Read request (Internal)
|
|
input wire write_rq, // Write request (Internal)
|
|
output reg [3:0] RAM_state, // State information (Internal)
|
|
output wire op_trigger // Event trigger wire
|
|
);
|
|
|
|
reg [2:0] read_init; // Whether or not a read operation has been initiated
|
|
reg trigger_low; // If trigger should be pulled low on next clock cycle
|
|
|
|
assign op_trigger = read_init == 3'b011;
|
|
assign RAM_enable = ~(read_init != 3'b000);
|
|
assign RAM_clk_enable = read_init != 3'b000;
|
|
|
|
assign RAM_clk = clk; // RAM clock tracks processor input clock
|
|
|
|
always @(posedge clk or posedge read_rq) begin
|
|
if(read_rq) begin
|
|
if(!read_init && !write_rq) begin
|
|
read_init <= 3'b001;
|
|
end
|
|
end
|
|
else if(read_init) begin
|
|
read_init <= read_init + 3'b001;
|
|
RAM_state <= 4'b0001; // STATE: read
|
|
end
|
|
end
|
|
|
|
always @(posedge write_rq) begin
|
|
if(!read_init && !read_rq) begin
|
|
//TODO: Implement read
|
|
end
|
|
end
|
|
|
|
endmodule
|